bend的示例

• Light rays bend as they pass from air to water.

• You'll snap that ruler if you bend it too far.

• the point where the road bends

• His new trousers ripped when he bent down.

• I bent down and picked up the coins lying on the road.

• He came off the road while driving his car around a bend at high speed .

• The river broadens out around the next bend.

• Be careful when you're cycling because there are several sharp bends along the route.

• The children are practising writing letters with lots of bends in them, like 's' and 'm'.

• Why does your cat have that funny little bend in her tail?

• These surfaces are distorted by hydrostatic balance toward negative anomalies of pressure produced by the bend of the low-pressure vortex cores.

• These degrees of freedom are represented by physical dimensions such as the depth of a notch or the angle of a bend.

• These authors reproduced a number of experimental observations using triangulated surfaces with elastic (stretching) and bending energy, where each capsomer is represented by several vertices.

• Higher discount rates bend supply backward more to generate multiple steady-state rational expectations equilibria.

• Since she could no longer bend her arm sufficiently, she had exchanged the violin for a mouth-organ.

• In this case the profile development was measured extensively, starting a t 2.5 diameters upstream of the bend.

• This increasing marginal benefit cushions the cost of restraining carbon use and contributes to a gentler bend in the cost curve.

• This flow slightly compresses and bends the current sheet.

• Effects of salt concentrations and bending energy on the extent of ejection of phage genomes.

• The hornblende lacks ductile bends and recrystallized margins.

• Turn the right foot to a 90 angle, inhale and as you exhale bend the right knee keeping the hips facing forwards.

• The perturbation of the exponential behaviour is most severe on the inner bend.

• This takes the form of a skew in the axial velocity profile such that the peak occurs a t the inside of the bend.

• A variety of bending motions must be generated with only a finite number of actuators.

• The bend sensors are accompanied by four to eight switch elements that are housed within a glove.