Príklady shim

• Before a race, he uses razor-thin shims to align the runners to .005 of an inch accuracy.

• The repair involves installing a steel shim a couple of millimetres thick in the pedal assembly.

• I was bolting them up using a bag full of shims.

• To bore perfectly square, deep holes, shimming the table where it joins its column support casting is necessary.

• The nut has been heavily shimmed in order to raise it.

• Small, broken stones shim the base of a large monument bearing the family name.

• In situations like these shims are most often used.

• Shims are used to snug up contact between the crib and supported object or change the direction of the crib (tilt).

• In this design, shims are installed between the two halves of the bearing housing and then the bore is machined to size.

• Sixteen valves are operated by a chain-driven double overhead camshaft; valve clearances are adjusted using shims.

• The valve clearance is adjusted using shims.

• Valve clearances are adjusted with under-lifter shims.

• In the integrated calculations, the shim was made up of a 200-mm-thick layer of density 0.01 g 0 cc iron foam placed on the sur face of the capsule.

• The cam lobes act directly on bucket type tappets, which are adjusted by means of shims between the underside of the bucket and the top of the valves.

• Top-hat shims offer a dramatic weight reduction over standard disc shims and are used in applications where valve-train weight reduction is important (i.e. high-performance road and race orientated engines).

• Let shim provide adequate facilities for treatment and do all he can voluntarily.

• If we accept paragraph (c) in its present form, we shall be tying the captains of our shim in a way against which they would indignantly protest.

• Though he tries to shim the difference with washers, they fall out, and he fails.

• To adjust the valve clearance, adjust the shims above the valve lifters (shim over bucket system).

• Video analysis also revealed a tile shim which came out during main engine start.

• The engine would first be assembled with a default shim of known thickness, then the gap measured.