Przykłady oscilloscope

• Neuronal signals were conventionally amplified and fed into a storage oscilloscope and a computer for further data processing.

• The data of the input voltage pulse sampled with a digital oscilloscope were fed into discharge simulating code.

• Receptive-field outlines were recorded on perimeter charts using oscilloscope and audio monitor.

• The proportion of time y that the flow a t a point was turbulent was obtained directly from the pulse length observed on the oscilloscope.

• Signals from the hot-film anemometer and the pressure cell were displayed simultaneously on the oscilloscope.

• This program can display amplitude and time-wave forms as well as create spectrograms with the help of a built-in double oscilloscope.

• The educed waveform can be displayed on an oscilloscope (figure 9) and still contains some noise.

• Formation of the bilayer was visualized on an oscilloscope screen as an increase of membrane capacitance, while applying a triangular voltage wave under voltage clamp.

• The digital oscilloscope was triggered by a visible plasma light signal from another photodiode which was placed 16 cm from the target.

• The interelectrode voltage was measured using a capacitative divider and oscilloscope.

• A diaphragmatic electromyogram was displayed on a storage oscilloscope as the average of 10 sweeps.

• The voltage across the probes was recorded on an oscilloscope.

• Figure 2 shows the oscilloscope traces of the typical incident and reflected waveforms at several incident energies.

• Adequacy of isolation was also monitored by display of detected spike waveforms on a digital oscilloscope with delayed triggering.

• The simultaneity of the six beams was monitored by a photodiode equipped with a digital oscilloscope.