Примери за woofer

• Here, the pendulum lines are vibrated from above (figure 16) using pumps made from modified woofers for strength and throw.

• Regardless of public perception or their rivals' negative assessments, fierce hiphoppers like these are skilled woofers.

• One such problem set as a task for a genetic program was to design a crossover filter for woofer and tweeter loudspeakers.

• The tweeter was mounted near the middle, with ten woofer panels occupying the remaining area.

• Without crossover points, the drivers would simply overheat and burn out, with exception of the woofer.

• The rotary woofer displaces far more air than is possible using moving cones, which makes very-low-frequency reproduction possible.

• If you refoam a woofer or a squawker it's very important to use the right ring-size.

• Additionally, some loudspeakers use the woofer to handle middle frequencies, eliminating the mid-range driver.

• To design a high efficiency woofer with extended low frequency ability, cones are usually extremely light and flexible with very compliant suspensions.

• There have been good and bad woofers made with every type of cone material.

• The larger the room, the more air the woofer's movement will have to displace in order to produce the required sound power at low frequencies.

• Many designers therefore believed this made them a good match to cone midranges and woofers, allowing for superb stereo imaging.

• Fortunately, replacement of the edge can be done by speaker repair shops and the woofer can then continue working well.

• The low frequency sound waves from the woofer are not reduced too much by the drivers in their path.

• The sensor measured the output signal of the woofer and compared it to the amplifier input signal.