0 a cut on the edge or corner of something that makes it slope slightly rather than being perfectly square
A slight rounded notch for the thumb, and a longer chamfer for three fingers, form the handle.
There is also the continuous chamfer course that ran along the walls above the heads of these aisle windows.
An example of these rules for chamfered assembly is given next.
We break the insertion problem down in to two phases: chamfer-crossing, and inserting (after chamfer-crossing) phase.
Our previous work19 deals with the analysis of the insertion problem during chamfer-crossing phase, briefly discussed in this section as follows.
The net forces and moment due to contacts between pegs and their chamfers can be calculated, based on the above assumptions.
Clearances between pegs and mating pairs were 0.1 mm, chamfers were set at 45 with 5 mm width.